TJ-II:Fast camera

TJ-II disposes of various fast camera systems for plasma imaging, a detailed description can be found elsewhere. .

Different topics have been studied such as Turbulence , Dust , or Spectroscopic 2-Dimensional Te and ne imaging,

The main system is located in sector B8, port B8TANG, viewing the poloidal limiter in sector C3 tangentially.

The TJ-II Visible Camera Team has installed in collaboration with NIFS (Japan) a Fast Camera in LHD Stellarator .

In the framework of EUROFUSION program, the group has leaded the installation and operation of the KL8 Wide Angle Visible Fast Camera in JET Tokamak (UK).

The latest upgrade and experiments with the ITER like Wall (ILW) are described elsewhere .

Cameras

Three Photron Fast Cameras (APX-RS and SA1) are employed at TJ-II Photron. Sampling speed (measured in frames per second, fps) and image size can be selected depending on active area of the MOS sensor, but there is a trade-off: 5000 fps with 1024 x 1024 pixels(full frame) and up to 200000 fps (maximum ever employed so far) with 182 x 80 pixels The dynamic range of the sensor is 8 bits, and the memory size is 8 GB.

Image Intensifier for Fast Camera

The coupling of an image intensifier to a High-speed camera is not trivial, since relatively high light intensity fluxes, sufficient for short exposure times down to the µs range, are captured continuously for a long time period, typically of up to some seconds. As is well known, imageintensifiers (as photomultipliers) are vulnerable to this combination and if not operated correctly, they can be damaged. Moreover, not only the amplification factor is important, but also the image quality and the responselinearity. Two Hamamatsu image intensifiers (C9548-03BL and C10880) [1] were tested and are successfully operated. They are two stage intensifier, including a first GEN II stage with a fast phosphor (P-46) and gain adjustable via the voltage at the MCP, and a second GEN I one (booster) with a fixed gain of 50. Both stages are optically coupled by a Fiber Optic Plate (FOP) which transfers the output signal from the first to the second. Their linear response is guaranteed up to 200000 fps speed.

Schematic diagram of the TJ-II fast camera installation

Videos

Below are some examples of movies recorded with the fast camera system of TJ-II. Click on the images to see the corresponding movie. Some of them contain Audio.

Double imaging to visualize the fine structure of Blobs at ultra-short exposure time of 100 ns

A visible fast camera coupled with an image intensifier was employed to view turbulent coherent plasma structures (Blobs) at the gas plume being puffed through a poloidal limiter. The image intensifier amplifies the light intensity thereby allowing the imaging system to be operated at ultra-short exposure times down to 100 ns. To distinguish real physical signal from noise we get two simultaneous images with the same view and compare them. We call this Double Imaging technique and it allowed us to validate the detected blob shape to scales down to a few millimetres, limited by our optical resolution.

Two-dimensional imaging of n_e and T_e showing ELM-like Edge Bursts

An intensified visible camera looks tangentially at a poloidal limiter where helium recycles, acting as a wide neutral source, and the atomic line emission due to plasma excitation becomes strongly localized there. It includes a bifurcated coherent bundle, each end with a different interference filter to select helium atomic lines, so that two simultaneous filtered images are captured in one single frame. The object of the proposed technique is to apply the well-known helium-beam line-ratio technique to obtain from selected filtered images the two-dimensional (2D) edge plasma n_e and T_e.

Dust Visualisation

Dust is observed in the TJ-II stellarator with a fast camera equipped with a bifurcated coherent fibre-bundle system that allows different set-ups such as dual filtering of atomic lines or a stereoscopic view to obtain tangential and perpendicular (to the magnetic field) observations simultaneously. The camera looks to a poloidal limiter that can be biased and it is observed that when a negative voltage is applied, dust from the limiter is ejected intensely once a certain threshold voltage is exceeded.

[[File:Dust.png|500px|link=http://www-fusion.ciemat.es/quixplorer/delaCal_dust.wmv]

First insertion of the poloidal limiter after a lithiation of the vacuum vessel. Tangential observation, 15 kHz sampling rate. The ejection of lithium flakes from the carbon surface can be seen clearly at the beginning of the discharge. At the end of the video, as the plasma becomes colder, the flakes penetrate deeper into it until they float freely in the collapsing discharge.

The Visible Intensified Fast Camera with Wide-angle view of JET ILW experiment

The JET wide-angle view Fast Camera has been upgraded with an image intensifier for light amplification and a filter wheel. The objective was to track fast events down to the microsecond range without filtering and to image atomic emission at a speed so as to resolve Edge Localised Modes (ELM), disruptions, pellet injection or plasma breakdown.