4,378
edits
(One intermediate revision by the same user not shown) | |||
Line 11: | Line 11: | ||
* One straight array in [[TJ-II:Sectors|sector]] C4, at ''φ'' = 308°. | * One straight array in [[TJ-II:Sectors|sector]] C4, at ''φ'' = 308°. | ||
* One poloidal array with 15 coils measuring the poloidal field component. This array is located between [[TJ-II:Sectors|sectors]] D4 and D5, at ''φ'' = 45°. The signals in the [[TJ-II:Shot database|TJ-II database]] corresponding to these coils are called 'MID5Px', where 'x' is the coil number. This array has been enhanced by 10 additional coils (5 at each end). | * One poloidal array with 15 coils measuring the poloidal field component. This array is located between [[TJ-II:Sectors|sectors]] D4 and D5, at ''φ'' = 45°. The signals in the [[TJ-II:Shot database|TJ-II database]] corresponding to these coils are called 'MID5Px', where 'x' is the coil number. This array has been enhanced by 10 additional coils (5 at each end). | ||
* Two toroidal arrays (installed 2018) | * Two toroidal arrays (installed 2018) <ref>E. Ascasíbar et al., ''Measurements of magnetic field fluctuations in TJ-II plasmas with new in-vessel helical arrays of magnetic coils'', [[doi:10.1063/5.0102037|Rev. Sci. Instrum. '''93''' (2022) 093508]]</ref> | ||
== Rogowski coils == | == Rogowski coils == | ||
Line 17: | Line 17: | ||
Two Rogowski coils have been installed in [[TJ-II:Sectors|sectors]] A5 (148.7°) and B4 (211.3°). Since the coils have to surround the plasma column completely, they are located under the protecting tiles of the groove that runs toroidally all along the [[TJ-II:Vacuum system|vacuum vessel]]. For this purpose, 2 mm deep channels were machined on the vacuum side of the groove, at the above mentioned poloidal cross sections, in order to allow enough space for the coils. | Two Rogowski coils have been installed in [[TJ-II:Sectors|sectors]] A5 (148.7°) and B4 (211.3°). Since the coils have to surround the plasma column completely, they are located under the protecting tiles of the groove that runs toroidally all along the [[TJ-II:Vacuum system|vacuum vessel]]. For this purpose, 2 mm deep channels were machined on the vacuum side of the groove, at the above mentioned poloidal cross sections, in order to allow enough space for the coils. | ||
The signals 'Ip_a5_' and 'Ip_b4_' in the [[TJ-II:Shot database|TJ-II database]] provide the corresponding measurements of the net plasma current. | The signals 'Ip_a5_' and 'Ip_b4_' in the [[TJ-II:Shot database|TJ-II database]] provide the corresponding measurements of the net plasma current (in kA). | ||
== Diamagnetic loops == | == Diamagnetic loops == |