4,427
edits
TJ-II:Construction: Difference between revisions
m
→Vacuum vessel
m (→Vacuum vessel) |
m (→Vacuum vessel) |
||
| Line 10: | Line 10: | ||
The octants with flanges have been manufactured separately and were assembled in-situ by welding. This assembly was done directly around the central conductor CC/HX, already placed in position. The CC/HX coil is outside of the vacuum vessel thanks to a helical groove built into the vessel. This groove has a wall thickness of 7 mm for clearance reasons. | The octants with flanges have been manufactured separately and were assembled in-situ by welding. This assembly was done directly around the central conductor CC/HX, already placed in position. The CC/HX coil is outside of the vacuum vessel thanks to a helical groove built into the vessel. This groove has a wall thickness of 7 mm for clearance reasons. | ||
Its groove is protected along the entire toroidal circumference against damage due to the bean-shaped plasma by 3 mm stainless steel sheets for low and medium power operation and graphite tiles for high power operation. Furthermore, the vacuum vessel is protected on the areas where the neutral beams deposit a residual shine-through heat flux. The vacuum vessel is pumped through four symmetrically spaced bottom ports to a base pressure of 10<sup>-8</sup> mbar. Four identical and independent vacuum pumping subsystems are used. | Its groove is protected along the entire toroidal circumference against damage due to the bean-shaped plasma by 3 mm stainless steel sheets for low and medium power operation and graphite tiles for high power operation. Furthermore, the vacuum vessel is protected on the areas where the neutral beams deposit a residual shine-through heat flux. The vacuum vessel is pumped through four symmetrically spaced bottom ports to a base pressure of 10<sup>-8</sup> mbar. Four identical and independent vacuum pumping subsystems are used. | ||
<ref>[http://dx.doi.org/10.1109/FUSION.1993.518387 J. Botija et al, '' Vacuum vessel, wall protection, pumping system and | <ref>[http://dx.doi.org/10.1109/FUSION.1993.518387 J. Botija et al, '' Vacuum vessel, wall protection, pumping system and poloidal limiters of the Spanish stellarator TJ-II'', 15<sup>th</sup> IEEE/NPSS Symposium on Fusion Engineering '''1''' (1993) 529-532]</ref> | ||
=== Coil system === | === Coil system === | ||